– 8 –
⓫ ⓭
⓮
❶ ❷ ❸ ❹ ❺❻ ❼ ❽ ❾
❿
⓬
⓯
⓰
Outline Diagram
1 Digital Display Window (see below)
2 Prog (Program) Pad
3 Shift (A/B/C) Pad
4 Power Level Selector Pad
5 Double/Triple Quantity Pad
6 +10s/+20s Pad
7 Number/Memory Pads
Time Input
8 Stop/Reset Pad
9 Start Pad
Door Handle
Air Filter
Splatter Shield (top of inner cavity)
Power Cord
Power Plug
Caution Label (Not shown)
OPERATING GUIDE
A—Program Display
B— Heating Time Display
(“min. sec.” or “hour min.”)
C— Memory Pad Number Display
Heating Stage Indicator
D—Pattern of Buzzer Sound Setting
E—Calling Programmed Heating:
Stage Number Indicator
Programmed Heating in Progress:
Operation Indicator
Beep Tone Setting: Scale Indicator
This oven is preset at the factory for the following:
1. Manual operation
2. Number Pads preset to HIGH power at the indicated heating times for single stage heating.
A1=10 sec. A2=20 sec. A3=30 sec. A4=40 sec. A5=50 sec.
A6=1 min. A7=1 min. 15 sec. A8=1 min. 30 sec. A9=1 min. 45 sec. A0=2 min.
3. Program unlock
4. Double Quantity=1.6 times Triple Quantity=2.2 times
5. Cycle counter set to “0” on all pads.
6. Oven Lamp When the door is open = ON Blinking at the end of heating cycle = OFF
Decrease brightness during cooking = OFF
7. The default filter cleaning time is set to “500”.
If you wish to change these times, please consult the operating instructions to find how to program them.
A B
E
C
D
To Next Page
Loading...
Need help?
General
