16 TELEMETRY SECURITY-SERVICE SYSTEM PANDORA PROFESSIONAL
Arming
Arming the system allows monitoring of all security zones, locks the doors and blocks
the engine.
To arm the system when the ignition is switched off, shortly press button on the
remote control. The siren will emit one sound signal and turn signals will flash once.
The remote control will play “ARMING” ringtone and security mode status icon (the
lock) will change to:
To arm the system without sound confirmation press and hold button for 1
second or more.
If doors, front hood or trunk was open when arming, the siren will sound 4 beeps instead
of 1, turn signals will flash 4 times, a remote will play the “WARNING” ringtone (after the
“ARMING” ringtone) and will show a troubled zone. This zone sensor will be disabled at that
moment. Sensor will be armed again in 15 seconds after the zone was set right.
Disarming
To disarm the system, shortly press button on the remote control. You will hear
2 short siren sounds and will see 2 flashes of turn signals. The remote will play
“Disarming”, ringtone and security mode status icon will change to:
~~
short press doors locking
system arming
1 ash
1 ash
1x
press and hold
for 1 sec.
~~
shortly
press
press
and hold for
1 sec.
doors unlocking
system disarming
2 ashes
2 ashes
2x
To Next Page
Loading...
Need help?
General
