59USER MANUAL
Beeper sound signals
Signal Description
Enable the Service mode 1 sound signal
Disable the Service mode 2 sound signals
A battery in a radio tag is discharged 3 sound signals / 3 times
Absence of a radio tag 5 sound signals / 5 times
Blocking warning Fast sound signals
Checking the number of recorded remote controls/radio tags/
mobile device
The number of recorded remote controls/radio tags/mobile device can be checked
by the number of orange, green and red flashes of the LED indicator. The number of
recorded remote controls/tags/mobile device can be checked when switching on the
ignition (the system must be disarmed). The number of orange flashes will indicate
the number of recorded remote controls, the number of green flashes will indicate the
number of recorded remote controls, a following red flash will indicate mobile device
is recorded.
You can also check the number of recorded tags and registered mobile device by
taking off and putting back on battery terminal. The system will emit short sound
signals from a siren with less than 1 sec. interval. The number of the signals equals to
the number of recorded remote controls. After a pause of 2 seconds the system will
emit short sound signals from a siren with less than 1 sec. interval. The number of the
signals equals to the number of recorded radio tags. After a pause of 2 seconds the
system signal will indicate registered mobile device.
To Next Page
Loading...
Need help?
General
