54 TELEMETRY SECURITY-SERVICE SYSTEM PANDORA PROFESSIONAL
CONTROL OVER THE SYSTEM IN CASE OF EMERGENCY
If you are not able to disarm the system using a remote control or radio tag, use a
phone to deactivate the system quickly. To disarm the system by a phone, call the
system’s number. When it answers, dial the 0* command. If the call is not made from
the owner’s number, the guest PIN- code should be entered. The factory preset of the
guest PIN-code is 1-2-3-4.
To disable the immobilizer tags, dial the 998* command (after dialing, enter
the ‘Secret PIN-code’ that is located on the owner’s plastic card). To enable the
immobilizer tags, dial the 888* command. If the system cannot be deactivated
using a phone, apply emergency disarming and enabling/disabling the
immobilizer tags using the VALET button
Emergency disarming using the VALET button
In case you cannot disarm the system using a phone or immobilizer tag, the
‘Secret PIN-code’ can be used. The ‘Secret PIN-code’ is written on the owner’s plastic
card under the protective layer. The code must be entered only when the base unit
is powered and the ignition is switched off. The PIN-code can be entered using an
WARNING! MAKE SURE THAT THE PROTECTIVE LAYER ON THE OWNER’S PLASTIC
CARD IS INTACT AFTER THE INSTALLATION OF THE SYSTEM. THE PLASTIC CARD HOLDS
THE ‘SECRET PINCODE’.
WARNING! CAREFULLY REMOVE THE PROTECTIVE LAYER, DO NOT USE SHARP
OBJECTS TO AVOID DAMAGING OF HIDDEN INFORMATION UNDER THE PROTECTIVE
LAYER.
To Next Page
Loading...
Need help?
General
