Pandora Light Pro Manual

28 SECURITYSERVICE SYSTEM PANDORA LIGHT PRO
2. Turn the key in the ignition lock to the OFF position (the engine should still be running) and take
it out of the lock.
3. Leave the car, close the doors.
4. Arm the system.
5. The engine will be stopped. Now the system is ready to perform remote and automatic engine
start.
Remote engine start
If the system is prepared for remote start, use one of the methods described below to start the engine.
Remote control
• Pressthe
button on the remote control and hold it for 3 second (when you are in the radio
coverage zone to start the engine. Sound signal will confirm the command, LCD will show flashing the
“engineisrunning”icon
signifying preparation to the engine start. In a few seconds the engine will
bestarted,theremotewillplaythe“Enginestart”ringtoneandshowspinningengineoperationicon.
The remote will give notification 1 minute before designated engine stop: the icon
will flash and
the“Enginestopin1minute”ringtonewillplayevery10seconds.Sendingthe“Remoteenginestart”
commandwhilethe“Enginestopin1minute”ringtoneisplayingwillextenditsoperationperiodby10
minutes. This procedure can be repeated multiple times.
system is armed
the engine is running
stop the engine
3 ashes
pres and hold
for 3 sec.
start the engine
the engine is running
3 ashes
pres and hold
for 3 sec.
add 10 minutes
press and hold
for 2 sec.
START
ENGINE
START
ENGINE
STOP
ENGINE
STOP
ENGINE
•Toremotelystoptheenginewhileitperformsheating,pressandholdthe button for 2 or more
seconds. The engine will be immediately stopped and it will be confirmed by remote playing the
“Enginestop”ringtoneandthe“Engineisrunning”icon
fading.
Engine start using an original car key
•Specialalgorithmsdetectsdigitalinformationofavehicleandallowtotostartandstoptheengine
using an original car key.

Pandora Light Pro Specifications

General

Brand	Pandora
Model	Light Pro
Category	Car Alarm
Language	English