TELEMETRY MODULE PANDORA NAV-X USER MANUAL16 17
Enter the ‘Service PIN-code” using the VALET button:
Press the button the number of times equals to the rst digit.
Pauses between presses should not exceed 1 second. Each
pressing will be conrmed with a green ash of the LED. A pause
for more than 1 second and a red ash of the LED conrm the
input of the rst digit. Then you can enter the next digit.
Enter the other digits in the same manner. The module will
conrm the correct PIN-code with the series of red and green
ashes.
Programming menu
Some functions can be changed only by the VALET button and
the “Programming menu”.
Use the VALET button to enter the desired level number after
entering the programming mode:
Press the button the number of times equals to level number,
pauses between presses should not exceed 1 second.
Level number Module function
Level #1
Pairing the module with a security-service
system
Level #2 Changing the “Service PIN-code”
Level №1 - Pairing the module with a security-service
system
Update rmware of the security-service system (base unit
rmware and Bluetooth modem rmware) before pairing.
The external power supply of the Pandora NAV-X module must be
connected during pairing.
Pairing procedure:
Enter the Level №10 or Level №10.8 (it depeneds on a system) of
the security-service system – Recording a telemetry module. The
LED indicator of the system will light green and the system will
enter the recording of the Pandora NAV-X module.
Enter the Level №1 of the telemetry module – “Level №1 – Pairing
the module with a security-service system”. If the procedure is
done successfully, the security-service system will sound a beep
and the LED will light green.
To nish pairing, briey press the VALET button of the security-
service system and the VALET button of the Pandora NAV-X module.
WARNING! ENABLE GPS AND SET CORRECT TIMEZONE IN
THE SETTINGS OF THE SECURITY-SERVICE SYSTEM AFTER
PAIRING THE MODULE
To Next Page
Loading...
Need help?
General