51
MT
GB
Setting up
that the hose runs to the front, so as not
3. Connect the feed hose to the water
supply and allow water to escape from
the other end of the feed hose with no
bubbles, in order to expel the air from
the feed hose. Switch off the water tap.
4. Connect the feed hose with the help of
-
-
-
-
container. It is sucked in automatically.
The roles of the unit, use the handle
The width of the jet can be in-
nozzle to the left. To reduce the
width of the jet, turn the end of the
Mains connection
an earthed wall socket with a residual
Only operate the pressure cleaner
after all the above points have been
observed.
1. Ensure that the pressure cleaner is
socket
Operation
Be prepared for the recoil
force of the emitted wa-
ter jet! Ensure that you are
are holding the gun (16) se-
curely, otherwise you could
injure yourself or other
people.
Never operate the pressure cleaner
with a closed water tap. Dry run-
cleaner!
1. Turn on the water tap entirely.
2. Switch on the pressure cleaner with the
Only ever switch on the pressure clean-
er once you have connected all of the
water pipes and they do not leak.
The motor switches on until the re-
the pressure has built up, the motor
switches off.
The nozzle operates by pressure and
the motor switches back on.
To Next Page
Loading...
Need help?
General
