52
GB MT
remains pressurised.
low water consumption work.
-
Turn the tip of the nozzle left to reduce
the width of the jet. Turn the tip of the
the jet.
-
sically used without pressure exertion.
The wash brush does not rotate if the
In the event of leaks in the
water system, switch off the
equipment immediately at the
on/off switch (7) and discon-
nect the equipment from the
mains at the mains power
cord. Risk of electric shock!
Start afresh with making the
water connections (cf. “Start-
up / Operation” from point 2.).
If there is still air in the device,
please proceed as follows:
To vent the supply hose:
-
water tap on until the water comes out
without bubbles.
2. Switch off the water tap.
3. Connect the supply hose to the water
-
4. Fully open the water tap.
To vent the equipment:
pressure has built up.
8. Please repeat process 5. to 7. a few
times until there is no more air in the
device.
• You can lock or unlock the start
Lock the starting lever (21) to
prevent the pressure cleaner
from being inadvertently / ac-
cidentally started.
Interrupting operation
off the pressure cleaner by its ON /
If the equipment falls over,
switch off the equipment
immediately at the on/off
switch (7) and disconnect the
equipment from the mains at
the mains power cord. Risk
of electric shock!
Only now
should the equipment be re-
turned to an upright position.
For your own safety, wait
approx. 5 minutes before re-
connecting to the electricity.
Ending operation
rinse the pressure cleaner with clear
water.
3. Turn off the pressure by its ON / OFF
To Next Page
Loading...
Need help?
General
