23
IntelliFlo Installation and User’s Guide
Features Mode
The Feature mode can be used with water features such as spa, cleaner, waterfalls, etc. You can schedule
start and stop times for each feature. All Features are operated using Flow control. The Feature mode and
Filter mode are run simultaneously. The three types of features are; Features 1 & 2, Features 3 -9 and
M.O. Flo:
Features 1 and 2
Feature 1 and Feature 2 run for a pre-defined duration with a specifically set flow. If Feature 1 or Feature 2
buttons are pressed, all other Features are temporarily deactivated. Feature 1 or Feature 2 cannot be used
in Backwash Mode. Features 1 and 2 have a higher priority than the pre-programmed Features 3-9. After
the preset duration time for the Feature 1(2), IntelliFlo will switch back to the “Filter” mode if the IntelliFlo
was in “Filter” mode when the Feature 1 (2) button had been pressed. After the preset duration time for the
Feature 1(2), the IntelliFlo will switch back to the “Manual” mode if IntelliFlo was in “Manual” mode when
the Feature 1 (2) button had been pressed.
Features 3 -9
Features 3 through 9 are only active in Filter mode. These features run a set flow for a specified time. The
Features 3-9 can not overlap.
M. O. Flo
The M. O. Flo feature automatically increases the pump flow to allow the system heater to check the water
temperature and switch on if necessary. This feature is only active when the pump is running a filter cycle.
Once the heater checks for heat and discovers it must fire it will send a signal back to IntelliFlo to go into
“Heater” mode. M.O. Flo only works during the “Filter” mode selected time cycles
To Next Page
Loading...
Need help?
General
