PerkinElmer Lambda 365 User Manual

Accessories . 69
7. Carefully lift up the tungsten lamp changing tool which holds the tungsten lamp
module and disconnect the tungsten lamp cable connector.
8. Loosen the cap screw on the tungsten lamp changing tool (Part No. N4102048) and
separate the tungsten lamp from the tool.
9. Replace the tungsten lamp with a new one and reassemble the parts in reverse order.

PerkinElmer Lambda 365 Specifications

General

Wavelength Range	190 - 1100 nm
Power Requirements	100-240 V AC, 50/60 Hz
Wavelength Accuracy	±0.3 nm
Wavelength Repeatability	±0.1 nm
Wavelength Reproducibility	±0.1 nm
Photometric Repeatability	±0.001 Abs
Baseline Flatness	±0.0005 Abs
Baseline Stability	<0.0003 Abs/hour (after warm-up)
Data Interval	0.1 - 5 nm
Light Source	Tungsten halogen lamp and deuterium lamp
Sample Compartment	Standard 10 mm cell holder
Detector	Silicon Photodiode