17
cover of the take-up
lever (5)
guide for the
right needle
thread (4)
thread tension
(3) of the right
needle thread
Raise the needle(s) to the highest position
by turning the handwheel towards you.
Guide the thread through the guide (4) for
the right needle thread and through the
take-up lever (5)
Guide the thread from the right between the
tension discs and pull the thread tight from
both sides.
Threading the right needle (green)
Place the spool on the second spool pin
from the left. The guide points for the right
needle thread are marked in green. Two
threading diagrams are located behind the
looper cover to help you with the threading.
Guide the thread from the rear through the
second thread guide (1) from the left. Guide
the thread through the fourth and the third
hole from the left on the thread guide plate
(2).
To Next Page
Loading...
Need help?
General
