42
Sewing problems and their solutions
This machine has been developed with ease of operation in mind. No difficult or tricky set-
tings need to be made. Sewing problems of the kind described below may occur as a result
of minor adjustment and operating errors. They can be easily adjusted by following the
instructions.
Problem Cause Solution
Needle breakage The needle was bent or the Insert new needle
point damaged. (see Page 22).
The needle was not fully inserted. Insert needle fully
(see Page 22).
The fabric was pulled too firmly. Do not pull on the fabric
when sewing.
Thread breaks Incorrectly threaded. Thread properly
(see Page 10 - 18).
Thread has caught. Check if the thread is caught
on the spool stand etc.
Thread tension is too tight. Correct the tension
(see Page 32 - 36).
Needle not fully inserted. Insert needle correctly
(see Page 22).
Incorrect needle used. Use needle system HAx1SP
(130/705 PS).
Skipping stitches Needle bent or point damaged. Insert new needle
(see Page 22).
Needle not fully inserted. Insert needle correctly
(see Page 22).
Incorrect needle used. Use needle system
HAx1SP (130/705 H-PS).
Incorrectly threaded. Thread correctly
(see Page 10 - 18).
Stitch Incorrect setting of thread tensions Re-set thread tensions
formation faulty (see Page 32 - 36).
To Next Page
Loading...
Need help?
General
