18
Feed the thread from the left to the right into
the right guide (6) for the needle thread.
Feed the thread from the left to the right into
the thread guide (7).
Feed the needle threading aid through the
needle eye from the rear. Then hook the th-
read end into the needle threading aid and
pull the needle threading aid with the thread
through the needle eye. Pull on the free
thread end until at least 10 cm (4”) is
showing beyond the needle eye. Lay the th-
read to the left under the presser foot.
Important note on threading
The needle(s) must always be threaded last
so that the needle threads do not run under
the looper thread as seen in drawing 1, but
instead over the looper thread as depicted
in drawing 2. Should this sequence not be
followed, thread breakage or skipped
stitches can occur.
If the looper threads break, you must pull
the needle threads out of the needle eye,
rethread the looper thread and then
rethread the needle threads.
guide (6 for the
needle thread
thread guide (7)
To Next Page
Loading...
Need help?
General
