Philips AJH510 User Manual

10 EN
5 Main features
Set alarm timer
Note
• Make sure that you have set the clock correctly.
1 In standby mode, press and hold ALARM
for 2 seconds to activate alarm setting.
» The hour digits blink.
2 Rotate VOLUME +/- to adjust hour.
3 Press ALARMtoconrm.
» The minute digits blink.
4 Repeat steps 2-3 to set the minute.
5 Repeat steps 2-3 to select an alarm source.
• BUZ and
icon: select buzzer as
alarm sound.
• Nx (1-5) and icon: select one from
theveprestoredsoundsasalarm
sound.
6 Repeat steps 2-3 to set the alarm volume.
» The alarm time and icon are displayed.
Theveprestoredsoundsarelistedbelow:
n1 Bell
n2 Jungle
n3 Bird
n4 Wake music 1
n5 Wake music 2
Activate/deactivate the alarm timer
Press ALARM repeatedly.
» The alarm icon appears if the alarm
timer is on and disappears if it is off.
Snooze alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing nine
minutes later.
Listen to relaxing music
With this alarm clock, you can get relaxed by
listening to realistic nature sounds and soft
music.
1 In standby mode, press MUSIC to activate
sounds stored in the alarm clock.
• To stop playing the music, press
MUSIC again.
2 Press MUSIC•TUNES repeatedly to select
a sound.

Philips AJH510 Specifications

General

AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Number of batteries supported	1
Snooze function	Yes
Package weight	730 g
RMS rated power	0.6 W
Display type	LED

Weight and Dimensions

Weight	350 g
Dimensions (WxDxH)	144 x 65 x 144 mm