Philips AJH510 User Manual

15EN
8 Troubleshooting
Warning
• Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page (www.
philips.com/support). When you contact Philips,
make sure that the device is nearby and the
model number and serial number are available.
No power
• Ensure that the power plug is connected
properly.
• Ensure that there is power at the AC
Mains.
• Ensure that the batteries are inserted
correctly.
No response from the alarm clock
• Disconnect and reconnect the AC power
plug.
Alarm does not work
• Set the clock/alarm correctly.
Clock/alarm setting erased
• Power has been interrupted or the power
plug has been disconnected.
• Reset the clock/alarm.

Philips AJH510 Specifications

General

AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Number of batteries supported	1
Snooze function	Yes
Package weight	730 g
RMS rated power	0.6 W
Display type	LED

Weight and Dimensions

Weight	350 g
Dimensions (WxDxH)	144 x 65 x 144 mm