EasyManuals Logo

Philips DCM250 User Manual

Philips DCM250
29 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
28 EN
Wait until the moisture condensation at
the lens has cleared.
Replace or clean the disc.
Use a fi nalized CD or correct format disc.
Cannot display some fi les in USB device
The number of folders or fi les in the USB
device has exceeded a certain limit. This
phenomenon is not a malfunction.
The formats of these fi les are not
supported.
USB device not supported
The USB device is incompatible with the
DCM250. Try another one.
Poor radio reception
Increase the distance between the
DCM250 and your TV or VCR.
Fully extend the FM antenna.
Timer does not work
Set the clock correctly.
Switch on the timer.
Clock/timer setting erased
Power has been interrupted or the power
cord has been disconnected.
Reset the clock/timer.
12 Troubleshooting
Caution
Never remove the casing of this DCM250.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
DCM250, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips web site (www.
Philips.com/welcome). When you contact
Philips, ensure that your DCM250 is nearby
and the model number and serial number are
available (see ‘Get started’ on page 13).
No power
Ensure that the AC power plug of the
DCM250 is connected properly.
Ensure that there is power at the AC
outlet.
As a power-saving feature, the DCM250
switches to standby automatically 15
minutes after disc/USB play reaches the
end and no control is operated.
No sound or poor sound
Adjust the volume.
Disconnect the headphones.
No response from the DCM250
Disconnect and reconnect the AC power
plug, then turn on the system again.
Remote control does not work
Before pressing any function button, fi rst
select the correct source with the remote
control instead of the main unit.
Reduce the distance between the remote
control and the DCM250.
Insert the battery with its polarities (+/–
signs) aligned as indicated.
Replace the battery.
Aim the remote control directly at the
sensor on the front of the DCM250.
No disc detected
Insert a disc.
Check if the disc is inserted upside down.

Other manuals for Philips DCM250

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Philips DCM250 and is the answer not in the manual?

Philips DCM250 Specifications

Sound IconSound
output power (RMS)2x15 W
sound systemStereo
loudspeaker typesBass Reflex Speaker System
Tuner/Reception/Transmission IconTuner/Reception/Transmission
tuner bandsFM, MW
station presets40
antennaFM Antenna
Connectivity IconConnectivity
usbUSB host
aux inYes
headphone3.5 mm
Dimensions IconDimensions
product width390 mm
product height140.5 mm
product depth200.5 mm

Related product manuals