Philips DVP5990 User Manual

English
15
TV
Antenna
1
Option 4: Using an accessory
RF modulator
Use this connection if your TV has only a
single Antenna input jack (labeled as
75 ohm or RF In).
A Connect the audio/video cables (supplied)
from the TV OUT and AUDIO OUT
L/R jacks on this unit to the video input
jack (yellow) and audio input jacks (red/
white) on the RF modulator.
B Connect a RF coaxial cable (not supplied)
from the ANTENNA OUT or TO TV
jack on the RF modulator to the antenna
input jack on your TV.
C Connect the Antenna or Cable TV
service signal (not supplied) to the
antenna or RF input jack on the RF
modulator (not supplied). (It may have
been connected to your TV previously.
Disconnect it from the TV.)
Helpful Hint:
– See your electronics retailer for details
about RF modulator availability and
operations.
Back of RF Modulator
(example only)
Basic Connections (continued)
dvp5990_5992_37_Eng1.indd 15dvp5990_5992_37_Eng1.indd 15 2008-03-10 10:47:22 AM2008-03-10 10:47:22 AM

Philips DVP5990 Specifications

Power

power supply frequency	50Hz
power supply voltage	230V
power consumption	< 12 W
standby power consumption	< 1.0 W

Sound

D/A converter	24 bit, 192 kHz
signal to noise ratio	> 90
distortion and noise (1kHz)	> 65 dB
crosstalk (1kHz)	> 70 dB
dynamic range (1kHz)	> 80 dB
frequency response	30-20000 Hz

Picture and Display

D/A converter	12 bit, 108 MHz
picture enhancement	Progressive scan, High Def (720p, 1080i, 1080p), Video Upscaling (720p, 1080i/p)

Weight and Dimensions

set dimensions	435 x 38 x 210 mm
packaging dimensions	490 x 82 x 296 mm
set weight	1.4 kg