Philips HTL2161B User Manual

12 EN
5 On the remote control, within six seconds
press twice then Volume + once, and
then hold down SURROUND ON.
» If an upgrade media is detected, on the
TV screen you are prompted to start
the update.
» If an upgrade media is not detected,
an error message is displayed on the
TV screen. Make sure that the latest
software of this product is put in the
USB storage device.
6 Press to start the update.
7 Wait until the update is completed.
» If the update is complete, this product
automatically turns off and on again.
Caution
• Do not turn off the power or remove the USB storage
device when the software update is in progress because
you might damage this player.
6 Wall mount
Note
• Improper wall mounting may result in accident, injury or
damage. If you have any query, contact Consumer Care
in your country.
• Before wall mounting, make sure the wall can support
the weight of your SoundBar.
• Before wall mount, you need not remove the four
rubber feet at the bottom of the SoundBar, otherwise
the rubber feet cannot be xed back.
Screw length/diameter
Depending on the type of wall mounting your
SoundBar, make sure that you use screws of a
suitable length and diameter.
See the illustration in the quick start guide on
how to wall mount the SoundBar.
1) Drill two holes on the wall.
2) Secure the dowels and screws in the holes.
3) Hang the SoundBar on the fastening screws.
> 25mm
3.5-4mm
4mm

Philips HTL2161B Specifications

General

Subwoofer type	Passive subwoofer
Subwoofer included	Yes
Subwoofer frequency range	45 - 200 Hz
Package type	80% recycled corrugated board, Soya based ink
Package depth	300 mm
Package width	790 mm
Package height	225 mm
Package weight	6300 g
FM radio	No
Product color	Black
TV stand usage	-
Audio formats supported	mp3
Consumer Electronics Control (CEC)	EasyLink
Impedance	8 Ω
Tweeter impedance	16 Ω
Number of tweeter drivers	1
Soundbar speaker RMS power	30 W
Total Harmonic Distortion (THD)	10 %
AC input voltage	110-240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.5 W
Docking connector type	Not supported
Sound enhancement technology	Treble and Bass Control
Subwoofer driver diameter (imperial)	5.25 \
Main unit weight	1400 g
Speaker output power	2 x 30W W
Subwoofer dimensions (WxHxD)	165 x 240 x 295 mm
Audio decoders	Dolby Digital
RMS rated power	120 W
Audio output channels	- channels
HDMI version	1.4
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired & Wireless

Weight and Dimensions

Width	- mm
Subwoofer depth	295 mm
Subwoofer width	165 mm
Subwoofer height	240 mm
Subwoofer weight	2500 g
Main unit dimensions (WxDxH)	843 x 60 x 52 mm