EasyManuals Logo
Home>Philips>Speaker System>HTL2161B

Philips HTL2161B User Manual

Philips HTL2161B
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
15EN
9 Notice
This section contains the legal and trademark
notices.
Notice of compliance
The device complies with the FCC rules, Part
15. Operation is subject to the following two
conditions:
a This device may not cause harmful
interference, and
b This device must accept any interference
received, including interference that may
cause undesired operation.
FCC rules
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance
with the instruction manual, may cause harmful
interference to radio communications.
However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or
more of the following measures:
Relocate the receiving antenna.
Increase the separation between
equipment and receiver.
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
FCC Radiation Exposure Statement:This
equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance of
20cm between the radiator and your body.
This transmitter must not be co-located or
operated in conjunction with any other antenna
or transmitter.
Warning: Any changes or modications made
to this device that are not expressly approved
by WOOX Innovations may void the user’s
authority to operate the equipment.
Model number: PHILIPS HTL2161B/F7
Trade Name: Philips
Responsible Party:P&F USA, Inc. PO Box 2248
Alpharetta, GA 30023-2248; 1 (866) 226-6074
Canada:
CAN ICES-3(B)/NMB-3(B)
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following Two conditions: (1) this
device may not cause harmful interference, and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
The device meets the exemption from the
routine evaluation limits in section 2.5 of RSS
102 and compliance with RSS-102 RF exposure,
users can obtain Canadian information on RF
exposure and compliance.
This transmitter must not be co-located or
operating in conjunction with any other antenna
or transmitter. This equipment should be
installed and operated with a minimum distance
of 20 centimeters between the radiator and
your body.

Other manuals for Philips HTL2161B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Philips HTL2161B and is the answer not in the manual?

Philips HTL2161B Specifications

General IconGeneral
Subwoofer typePassive subwoofer
Subwoofer includedYes
Subwoofer frequency range45 - 200 Hz
Package type80% recycled corrugated board, Soya based ink
Package depth300 mm
Package width790 mm
Package height225 mm
Package weight6300 g
FM radioNo
Product colorBlack
TV stand usage-
Audio formats supportedmp3
Consumer Electronics Control (CEC)EasyLink
Impedance8 Ω
Tweeter impedance16 Ω
Number of tweeter drivers1
Soundbar speaker RMS power30 W
Total Harmonic Distortion (THD)10 %
AC input voltage110-240 V
AC input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Docking connector typeNot supported
Sound enhancement technologyTreble and Bass Control
Subwoofer driver diameter (imperial)5.25 \
Main unit weight1400 g
Speaker output power2 x 30W W
Subwoofer dimensions (WxHxD)165 x 240 x 295 mm
Audio decodersDolby Digital
RMS rated power120 W
Audio output channels- channels
HDMI version1.4
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technologyWired & Wireless
Weight and Dimensions IconWeight and Dimensions
Width- mm
Subwoofer depth295 mm
Subwoofer width165 mm
Subwoofer height240 mm
Subwoofer weight2500 g
Main unit dimensions (WxDxH)843 x 60 x 52 mm

Related product manuals