onlinecomponents.com
IBSL SYS PRO UM E
1-18 6057AC01
1.7 Mounting INTERBUS Loop Modules
Make sure you observe the minimum distances when mounting BK
modules above each other (see "Mounting Distances for BK Modules With
IP 20 Protection" on page 1-13).
1.7.1 Mounting BK Modules With IP 20 Protection
Figure 1-14 Mounting and removing BK modules
Grounding • Install a clean and corrosion-free mounting rail (DIN EN 50022,
Phoenix Contact: Designation NS 35) on the mounting surface.
Connect the mounting rail to protective earth ground with a
grounding terminal. The modules are grounded when they are snapped
onto the mounting rail.
Mounting position The mounting position can be as desired.
Mounting • Place the module onto the mounting rail from above (Figure 1-14, left).
• Push the module towards the mounting surface.
• Secure the module to the right and to the left with end clamps or
grounding terminals.
Removing terminals • For removal, insert an appropriate tool into the latch
(Figure 1-14, right).
• Pull the tool upwards.
• Pull the module off in vertical direction to the rail.
6 0 5 7 A 0 1 4
A
A
B
B
To Next Page
Loading...
Need help?
General
