03_32
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EUROPEAN STANDARDS RE-
GARDING MAXIMUM AND MINIMUM HEIGHT OF LIGHT BEAMS. REFER TO THE
STATUTORY REGULATIONS IN FORCE IN EVERY COUNTRY WHERE THE VE-
HICLE IS USED.
03_33
03_34
Frontdirectionindicators (03_33, 03_34, 03_35)
To replace a burst bulb:
1. Remove the driving mirrors, by lifting the cover and loosening the two screws "A"
on both sides.
2. Remove the front turn indicator light assembly cover, by loosening the four fixing
screws "B".
3. By loosening the two fixing screws "C" remove the turn indicator light;
To reassemble, repeat the operation in the reverse order.
WARNING
HIGH- AND LOW-BEAM BULBS ARE HALOGEN TYPE: DO NOT TOUCH THEM
WITH YOUR FINGERS TO AVOID DAMAGING THEIR FUNCTION.
63
To Next Page
Loading...
Need help?
General