Pioneer A-70-K User Manual

Operation 04
13
En
English
DeutschFrançais
Nederlands
Italiano Español Русский
To set for automatic standby status (Auto Power Down)
This function automatically switches the unit to standby mode if no signal or switch operation is detected for 30
minutes.
1 If the unit’s power is ON, press the APD button on the remote control.
When this condition is set to ON, the STANDBY/APD indicator on the unit’s front panel will light green. Press the
buttons again to disable the setting.
• This setting can also be made by pressing the front panel LOUDNESS button and POWER AMP DIRECT button
simultaneously and holding them depressed for 3 seconds.
• The factory default setting is ON.
•Rotating the TREBLE, BASS, BALANCE, or VOLUME controls will not be counted as a control operation for
purposes of resetting the Automatic Power-Down 30-minute timer.
Note
• Depending on the device connected, excessive noise produced by the device may be interpreted as an audio
signal, thus preventing the Automatic Power-Down function from operating.
Restoring all the settings to the factory default settings
1 When power is in standby mode, hold the front-panel’s SPEAKERS A button and
POWER AMP DIRECT button depressed simultaneously for five seconds.
2 Turn power ON to the unit.
A70_SYXE8.book 13 ページ ２０１２年７月２７日 金曜日 午後６時５３分

Pioneer A-70-K Specifications

General

Amplifier class	D
Output impedance	32 Ω
Audio output channels	2.0 channels
Peak power per channel	180 W
Subsonic filter frequency	20 - 20000 Hz
Signal-to-Noise Ratio (SNR)	- dB
Total Harmonic Distortion (THD)	0.5 %
Pre out port	Yes
Speaker selector	A+B
Headphone connectivity	3.5 mm
USB 2.0 ports quantity	1
Speakers connectivity type	RCA
Purpose	Home
Product color	Black
Volume control	Digital
Connectivity technology	Wired
AC input voltage	220-230 V
AC input frequency	50 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	74 W

Weight and Dimensions

Depth	361.5 mm
Width	435 mm
Height	141.5 mm
Weight	17100 g