17
Basic Operation
Corresponding Display Indications and Buttons
This product’s display features Key Guidance Indicators. These light to indicate which of
the 5/∞/2/3, FUNCTION, AUDIO and DSP buttons you can use. When you’re in the
Function Menu (refer to next section), Detailed Setting Menu (refer to page 20), Initial
Setting Menu (refer to page 55), Audio Menu 1, 2 (refer to page 44, 46) or DSP Menu 1, 2
(refer to page 47, 52), they also make it easy to see which 5/∞/2/3 buttons you can use
to switch functions ON/OFF, switch repeat selections and perform other operations.
Indicator and corresponding buttons are shown below.
7 Head Unit 7 Steering Remote 7 Display
Controller
When 1 is lit in the display, perform appropriate operations with the z buttons.
When 2 is lit in the display, it indicates that you are in the Function Menu, Detailed
Setting Menu or Initial Setting Menu. You can switch between each of these menus and
between different modes in the menus using button x on the head unit or steering remote
controller.
When 3 is lit in the display, it indicates you are in the Audio Menu 1, 2. You can switch
between modes in the Audio Menu 1, 2 using button c on the head unit.
When 4 is lit in the display, it indicates you are in the DSP Menu 1, 2. You can switch
between modes in the DSP Menu 1, 2 using button v on the head unit or steering remote
controller.
Entering the Function Menu
The Function Menu lets you operate simple functions for each source.
Note:
• After entering the Function Menu, if you do not perform an operation within about 30 seconds, the
Function Menu is automatically canceled.
1. Select the desired mode in the Function Menu. (Refer to next section,
“Function Menu Functions”.)
Each press changes the Mode ...
To Next Page
Loading...
Need help?
General
