95
Using other functions
10
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to MULTI ZONE OFF.
! Disconnect the iPod and USB memory device from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI Setup on page 86 ).
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select ‘RESET’ using PRESET k/l, then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
! Note that all settings will be saved, even if the receiver is unplugged.
Default system settings
Setting Default
SPEAKERS
SB/TMd ON<a>/
ON<b>
Speaker System 7.2ch/5.2.2ch<a>/5.2ch<b>
Speaker Setting
Front
SMALL
Center
SMALL
TMd
<a>
SMALL
FW
<a>
SMALL
Surr
SMALL
SB
<a>
SMALLx2
SW
YES
Surround Position
<a>
ON SIDE
Crossover
80Hz
X-Curve
OFF
DIMMER Brightest
Inputs
See Input function default and possible settings on page 63 .
Input Volume Absorber All Inputs
0dB
HDMI
HDMI Audio
AMP
Control
OFF
Control Mode --- (OFF)
ARC (Audio Return Channel) --- (OFF)
Standby Through
OFF
4K/60pBD
4:2:0
4K/60pH1 (HDMI IN 1)
4:2:0
Setting Default
4K/60pH2 (HDMI IN 2)
4:2:0
DSP
Power On Level
LAST
Volume Limit
OFF
Mute Level
FULL
Phase Control
ON
Auto Sound Retriever
OFF
Sound Delay 0 ms
Dual Mono
CH1
DRC
OFF
LFE Attenuate
0dB
Auto delay
OFF
Digital Safety
OFF
Effect Level ALC (Auto Level Control)
50
Center Spread
<a>
OFF
PL II Music Options
<b>
Center Width
3
Dimension
0
Panorama
OFF
Neo:6 Options Center Image
Neo:6 CINEMA: 10
Neo:6 MUSIC: 3
All Inputs
Listening Mode (2 ch/multi ch)
AUTO SURROUND
Listening Mode (Headphones)
STEREO
See also Setting the Audio options on page 89 for other default DSP settings.
MCACC
MCACC Position Memory
M1. MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 10’00’’
Standing Wave (M1 to M6)
ATT of all channels/filters 0.0 dB
SWch Wide Trim 0.0 dB
EQ Data (M1 to M6)
All channels/bands 0.0 dB
EQ Wide Trim 0.0 dB
Network
Network Standby
ON
DHCP
ON
a VSX-90 only.
b VSX-45 only.
To Next Page
Loading...
Need help?
General
