Polaris DP-20 User Manual

DP-20 WEB GUIDE CONTROLLER USER MANUAL
6
6-4
7. Press the ENTER key. WAIT... will be displayed
for a few seconds on line 4 of the LCD Panel.
Maintain the web position during this wait
period.
8. Once the delay has ended, COVER SENSOR
will be displayed on line 2. Fully cover the
sensor field of view with the web material to be
guided (see graphic at right). The sensor signal
is displayed on Line 3.
Web
Sensor
9. Press the ENTER key. If the contrast is
sufficient for guiding, SUCCESSFUL will be
displayed for a few seconds on line 2, then the
unit will automatically exit the menus and return
to the Operator Level.
—OR—
10. If the contrast is not sufficient for guiding,
FAILED will be displayed on line 2. Press the
MANUAL key to exit the setup menus and
return to the Operator Level. Repeat this
procedure, as necessary.
Ø 3B.1.4.2
UNCOVER SENSOR
-ÜÜÜÜÜÜÜÜÜÜ+ 0%
WAIT...
06-05-2007 DP-20 WEB GUIDE CONTROLLER Figure Sheet 1-862-D
3X.1.4, Calibration, Line Sensor, Center of Line Guiding
1. Press the SETUP key to enter the Setup
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
2. Press the ENTER key to enter the BASIC
Menus. The GAIN menu will be displayed.
3. Use the ARROW keys to scroll until
CALIBRATION is displayed on line 3.
4. Press the ENTER key to enter the
CALIBRATION menu. SELECT SENSOR will
be displayed on line 3.
Ø 3B.1.4.3
COVER SENSOR
-ãããããããããá+ 95%
Ø 3B.1.4.6
FAILED
-áÜÜÜÜÜÜÜÜÜ+ 3%
Ø 3B.1.4.4
SUCCESSFUL
-ãããããããããá+ 95%
3B
MANUAL
Ø -ãããããáÜÜÜÜ+
ý 3D.1.1
SETUP (MAN)
GAIN
ãÜÜÜÜÜÜÜÜÜ 10.0%
ý 3D.1.4
SETUP (MAN)
CALIBRATION
ý 3D.1
SETUP (MAN)
SELECT MENU
BASIC
ý 3D.1.4.1
SETUP (MAN)
SELECT SENSOR
(X4)

Polaris DP-20 Specifications

General

Brand	Polaris
Model	DP-20
Category	Controller
Language	English