DP-20 WEB GUIDE CONTROLLER USER MANUAL
6
6-14
6. Use the ARROW keys to scroll to the desired
selection as indicated on line 4 of the LCD
Panel. YES indicates that the corresponding
operation mode is enabled. NO indicates it is
disabled.
7. Press the ENTER key to store the change or
press the MANUAL key to abort the change.
The system will exit the setup menus, and
return to the Operator Level.
× 3A.2.2.2
SETUP (MAN)
|AUTO|SC |MAN |
|NO |YES |YES |
× 3A.2.2.3
SETUP (MAN)
|AUTO|SC |MAN |
|YES |NO |YES |
× 3A.2.2.4
SETUP (MAN)
|AUTO|SC |MAN |
|YES |YES |YES |
3A
MANUAL
× -ãããããáÜÜÜÜ+
3X.2.3, Set Sensor Mode Enable, Edge Sensors
1. Press the SETUP key to enter the Setup
Menus. The SELECT MENU screen will be
displayed on the LCD Panel.
2. Use the ARROW keys to scroll until SPECIAL
is displayed on line 4.
3. Press the ENTER key to enter the Special
Menus. The DEADBAND menu will be
displayed.
4. Use the ARROW keys to scroll until SENSOR
ENABLE is displayed on line 3. The current
selection is displayed on Line 4.
5. Press the ENTER key to enter the Sensor
Enable menu. The current selection will begin
flashing on line 4. The last digit of the menu
number will vary according to the current
selection.
× 3A.1
SETUP (MAN)
SELECT MENU
BASIC
× 3A.2
SETUP (MAN)
SELECT MENU
SPECIAL
× 3A.2.1
SETUP (MAN)
DEADBAND
-ÜÜÜÜÜÜÜ+ 0.0%
× 3A.2.3
SETUP (MAN)
SENSOR ENABLE
| × | Ø | ×Ø |
× 3A.2.3.1
SETUP (MAN)
| × | Ø | ×Ø |
|YES |YES |YES |
06-05-2007 DP-20 WEB GUIDE CONTROLLER Figure Sheet 1-862-D
To Next Page
Loading...
Need help?
General
