26
FEATURES AND CONTROLS
Roll-Over Protection System (ROPS)
The Rollover Protective
Structure (ROPS) on this
vehicle meets OSHA 1928.53
rollover performance require-
ments. Always have your
authorized Polaris dealer thor-
oughly inspect the ROPS if it
ever becomes damaged in any
way.
No device can assure occu-
pant protection in the event of
a rollover. Always follow all
safe operating practices out-
lined in this manual to avoid
vehicle rollover.
WARNING! Vehicle rollover could cause severe injury or death. Always avoid
operating in a manner that could result in vehicle rollover.
Seat Removal
Pull up on the front of the seat and slide it toward the front of the vehi-
cle.
Install the seat by sliding the tabs into the rear of the seat base. Push
down firmly on the front of the seat until the pins are fully seated into
the grommets.
Fuel Cap
The fuel tank filler cap is located
on the right-hand side of the vehi-
cle near the passenger seat. When
refueling, always use either leaded
or unleaded gasoline with a mini-
mum pump octane number of 87
R+M/2 octane. Do not use fuel
with ethanol content greater than
10 percent, such as E-85 fuel.
To Next Page
Loading...
Need help?
General
