7.40
FINAL DRIVE
Gearcase Assembly
1. Install a new input shaft seal using a standard seal installer
or other suitable method.
2. Install new seals on each side of the gearcase housing using
a standard seal installer or other suitable method. Install a
new O-ring in the gearcase cover.
3. If removed, install each axle spool bearing race using
standard bearing installation tools and an arbor press.
WARNING
Wear the appropriate safety equipment while
installing bearing races to
reduce the risk of injury.
www.midwestmanuals.com www.green-manuals.com
To Next Page
Loading...
Need help?
General
