7.4
9940259 R02 - 2022 RZR PRO R / PRO R 4 Service Manual
© Copyright Polaris Industries Inc.
SHIFT CABLE ADJUSTMENT
1. Locate the shift cable attached to the transmission
case in the right rear wheel well area.
2. Inspect shift cables, clevis pin, pivot bushings, and
dust boots. Replace if worn or damaged.
3. If adjustment is required, loosen the top adjustment
nuts
q
to the top of the threads.
4. With approximately 5-20 lbs. of force, pull each cable
sheathing
w
downwards from below the cable
holding bracket to make the cables taut.
5. While pulling the cable sheathings taut, hand-tighten
bottom nuts
e
on both cables until approximately 5-6
mm of thread shows between the cable crimp and
nut, and nuts are fully seated against the bracket.
6. Thread top adjustment nut down until fully seated on
the bracket, then loosen the nut by one full rotation.
7. While counter-holding each top nut, torque bottom
nuts against the bracket.
TORQUE
Shift Cable Jam Nuts:
7 ft-lbs (10 Nm)
8. Once the proper adjustment is obtained, check shifter
free-play. free play should be no more than 5 mm.
NOTICE
This procedure may require a few attempts to obtain
the proper adjustment.
IMPORTANT
Approximately 5 mm of free-play for the shifter rod is
normal due to gear selector engagement in the
transmission. Do not attempt to adjust cables to
decrease this normal free-play amount. This may
damage the shift cables.
9. Turn ignition on and check travel of the shifter
throughout the gear range. Ensure each gear selects
positively, and the selected gear is properly displayed
on the gauge cluster.
TRANSMISSION
To Next Page
Loading...
Need help?
General
