Polaris Virage TX 2000 Service Manual

Engine Removal
Refer to illustration on pages 4.5-4.12 during engine
removal. Photos shown are for Genesis FFI ™. Gen
esis and carb. model differences are noted where ap
plicable.
1 . Turn off fuel valve if applicable.
2 . Remove seat. Apply masking tape or duct tape
around seat opening to protect hull from
scratches during engine lifting procedures.
ENGINE
Engine Removal - Polaris Engines
3. Loosen bolts and remove air intake silencer
assembly.
4 . Remove spark plug high tension leads from spark
plugs.
5 . Remove straps securing exhaust water box.
6 . Disconnect stator wires from connector, and
remove temperature sender wire from terminal
board. Move electrical box out of the way to
complete battery ground (-) cable removal. On
Genesis FFI™, remove wires from EMM and
electrical box.
7 . Disconnect battery ground (-) cable from rear of
engine crankcase.
8 . Loosen clamp and remove hose from water outlet
manifold.
9 . Remove exhaust pipe and exhaust silencer.
10 . Remove exhaust manifold.
11 . Remove cable from starter motor.
12 .Genesis models - Remove coupler shroud from
bracket.
Carb. models - Spin coupler back until it clears
crankshaft. Pump and/or drive shaft removal is
not necessary for engine removal.
13.Remove jet pump and driveshaft assembly.
Refer to Final Drive-Jet Pump-Bilge section for
procedure.
14 . Disconnect oil supply line at oil pump and plug the
line.
Polaris Sales Inc.
4.13
3/00

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English