Polaris Virage TX 2000 Service Manual

5. Remove four (4) mounting bolts.
6.
7.
Pump removal is easier if an assistant pushes the
driveshaft out of the engine coupler (inside hull)
while the pump is removed. Note interlocking tabs.
They must be correctly aligned during reassembly.
Remove pump and shaft as an assembly.
NOTE: The bearing housing (near engine coupler)
should be inspected when pump/driveshaft is removed.
8.
On models with extended pump, remove pump
extension.
9.
Remove driveshaft from impeller by pulling straight
outward.
NOTE: If the pump housing, intake scoop, or ride plate
must be removed, refer to page 5.21.
Drive Shaft Inspection
1. Clean driveshaft and support in V - blocks as shown
(C). Measure runout by rotating shaft and
observing dial indicator at point "B". Replace if
runout exceeds the service limit.
NOTE: Excessive driveshaft runout can cause vibra
tion, bearing, and spline failure. See Pump/Final Drive
Troubleshooting at the end of chapter 2.
FINAL DRIVE/JET PUMP/BILGE SYSTEM
Pump Disassembly/Inspection
Place dial indi
cator
at "B"
Support in V-blocks
at "C"
Polaris Sales Inc.
5.13
3/00

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English