Polaris Virage TX 2000 Service Manual

FINAL DRIVE/JET PUMP/BILGE SYSTEM
Intake Scoop and Ride Plate Installation
Intake Scoop / Ride Plate Installation and Sealing, All Models
IMPORTANT! The area around the intake scoop and ride plate must be completely sealed in order to prevent
ventilation of the pump area (cavitation). Prepare pump housing for installation before applying sealant. See
Ventilation/Cavitation page 5.30 for more information.
1.
If ride plate or intake scoop has been removed,
clean a//old sealant from hull mounting area. Apply
a 1/2" (1.3 cm) or larger continuous bead of marine
grade silicone sealant to the area shown. Be sure to
apply sealant between hull and inlet scoop shown
by arrows.
2. Install intake scoop, carefully push into place.
3. Set ride plate in place and secure it with attaching
screws. Wipe off any excess sealant inside scoop
area so water flow is unobstructed. For precise
alignment of the scoop, install the pump housing
immediately (see pump installation).
IMPORTANT! Allow sealant to cure for 12 hours before
operating the craft.
3100
5.10
Polaris Sales Inc.

Polaris Virage TX 2000 Specifications

General

Brand	Polaris
Model	Virage TX 2000
Category	Boat
Language	English