• Setting the Flash Mode
The Flash Range is approximately 4 feet to 8 feet (1.2 to 2.4 meters).
1. Turn on the camera.
2. Set the Mode selector to Capture mode (the Status LED blinks once).
3. Press Flash button to cycle through the ash mode until the one you
want is shown on the LCD screen.
Flash mode on, the ash res for every picture. Use this setting
indoors in low light.
Flash mode off, the ash does not re. Use this setting for outdoor
pictures or where ash is prohibited or may be distracting. Also use
when shooting toward a reective surface, such as a window or
mirror. If you do not have enough light when using this setting, your
pictures will be too dark.
Auto Flash mode, the ash res automatically as needed. Use this
setting to take most pictures.
Please note that when ash mode is selected, the Status LED turns green
and blinks until the ash nishes charging, then the Status LED will be on
until pressing Shutter button to take a picture.
• Zoom in and out
Your camera is designed to have 3X digital Zoom. This feature lets you
“zoom” in on the central area of a photo and photograph only the enlarged
portion of the picture. Digital zoom applies to only one photo at a time. To
Zoom in and out the picture, press Down/Up button.
NOTE:
This feature is available in Capture and Playback mode.
To Next Page
Loading...
Need help?
General
