110-240 41
Command Description
Command
Format
Values Return Message
Read float switch status RX[CR]
0 = fluid level is ok
1 = fluid level is low
0[CR] or 1[CR]
Read fault status
(see Display, Alarm and Error
Messages)
RF[CR]
00 = System OK
18 = Standby mode
02 – 17 = Fault
![CR]
Equipment Disposal (WEEE Directive)
or
This equipment is marked with the crossed out wheeled bin symbol to indicate it is covered by the Waste
Electrical and Electronic Equipment (WEEE) Directive and is not to be disposed of as unsorted municipal waste.
Any products marked with this symbol must be collected separately, according to the regulatory
guidelines in your area.
It is your responsibility to correctly dispose of this equipment at lifecycle-end by handing it over to an authorized
facility for separate collection and recycling. It is also your responsibility to decontaminate the equipment in case
of biological, chemical and/or radiological contamination, so as to protect the persons involved in the disposal and
recycling of the equipment from health hazards. By doing so, you will help to conserve natural and environmental
resources and you will ensure that your equipment is recycled in a manner that protects human health.
Requirements for waste collection, reuse, recycling, and recovery programs vary by regulatory authority at your
location. Contact your local responsible body (e.g., your laboratory manager) or authorized representative for
information regarding applicable disposal regulations.
Service and Technical Support
If you have followed the troubleshooting steps and your Recirculating Chiller fails to operate properly, contact the
supplier from whom the unit was purchased. Have the following information available for the customer service
person:
• Model, Serial Number, and Voltage (from back panel)
• Date of purchase and your purchase order number
• Suppliers' order number or invoice number
• A summary of your problem
To Next Page
Loading...
Need help?
General
