PowerMate
Operation Manua
LOADING SAFETY
SAFETY IN MOTION
CAUTION: Never lift a load that is over the rated capacity of the PowerMate
unit.
Estimate the weight and center of gravity position of the load and refer to the unit
Load Capacity Chart to ensure the load is within the loading envelope. The capacity
may be limited by the weight and strength of the operator(s). Do not operate with a
load that is beyond the operator's physical ability.
Do not attempt to increase the load capacity of the equipment by the use of chains,
rope, or other means of securing the equipment to the bed or bodies of vehicles,
handrails, wall brackets, etc..
Operators shall determine the balance of unfamiliar loads prior moving the load.
Work performed in a balanced condition is done easier and safer. New operators
should gain practice experience with lighter loads of approximately 250 lbs. with a
medium center of gravity before progressing to heavier loads. Do not raise or lower
the load too far past the balance point. Jog the equipment control switches so as
not to transfer the load weight too quickly. Training is mandatory!
Ensure the load is not damaged, properly packaged, no loose items such as tools
used in packaging the load and sharp items (such as nails) projecting from the
load.
Protect the PowerMate
®
strapping material from sharp edges to prevent strap
failure. Always inspect straps prior to use. Insure the strapping latching mechanism
is fully engaged.
Verify load secureness at the beginning of use, and prior to climbing or descending
with the load. Check for any loose items or load shifting.
Never unstrap a load with the PowerMate
®
unit in an open (extended) condition.
The unit will fall over backwards if the wheels are not in contact with a stable
surface when the unit is unloaded.
Do not load the PowerMate
®
unit with a load center of gravity that is outside the
side to side limits of the unit wheels.
CAUTION: When transiting a surface, avoid high speed turns that may cause
the load and PowerMate
®
unit to tip. Remember that the load must be secure
to the PowerMate
®
unit to ensure the load cannot shift.
When transiting the unit without a load, ensure the load strapping devices are
secure, not dangling, to prevent a trip hazard and prevent entanglement in the
PowerMate
®
moving parts.
Always keep your attention in the direction you are moving, monitoring
clearances above, below, and each side of the PowerMate
®
and load. When
visibility is obstructed use spotter person for directional instruction and/or clear
path of obstacles and un-involved personnel.
2.06
PN 010130 Rev.E
Eng. 05/ 08/ 14
To Next Page
Loading...
Need help?
General
