Installing the Console 51
4. Line up the two small tabs at the bottom of the console’s
back cover with the slots at the bottom of the console
case. Insert the tabs into the slots.
5. Insert the two #8–32 × ¹₂-inch Phillips-head screws that
you removed earlier into the holes at the top edge of the
console’s back cover. Tighten the screws fully.
Important: If you are installing a console that is equipped
with a Personal Viewing System (PVS), use caution not to
pinch the cables between the back cover and PVS mounting
screw heads.
Reassembling the Treadmill Fairing
After the console is in place, reattach the two cover panels of
the treadmill fairing.
Important: In the following procedure, do not allow the fasteners
to break or pinch any cables.
To reassemble the fairing:
1. Verify that all cables are secure inside the cable ties.
2. Install one of the access covers over the opening above
the appropriate upright support. Slide the two tabs under
the edge of the opening as shown in the following figure.
Figure 30: Access panel positioning
3. Secure the access cover with two ¹₄-inch × 1-inch
buttonhead screws.
To Next Page
Loading...
Need help?
General
