68 Assembling and Maintaining TRM 800-Series Treadmills
Using the Treadmill Safety Clip
The treadmill is equipped with three different stop functions,
which behave as follows:
If the user … Then the treadmill
belt …
And the console …
Pulls on the lanyard
attached to the safety
clip and trips the
restart switch
Slows to a stop Shows the words PUSH
THE RESET SWITCH.
On some console
models, an arrow
points toward the
Restart switch.
Presses down on the
red STOP button
Slows to a stop Shows that the exercise
workout is paused.
Steps off of the
running belt for a
preset amount of
time
Slows to a stop Shows that the exercise
workout is paused.
The restart switch and the red STOP button are located just
below the console, as shown in the following figure. When the
switch is tripped, the button pops up. The treadmill does not
operate until the button is returned to its normal position.
Figure 36: Restart switch