72 Operating and Maintaining the P80 Console
To clean the screen:
The manufacturer recommends diluting one part 91%
isopropyl alcohol solution in one part water, or using the
91% isopropyl alcohol solution in its original strength. Be
sure to follow the solvent manufacturer’s precautions and
directions when using any solvent.
CAUTION: Potentially hazardous situations associated with
the use of isopropyl alcohol may result in minor or moderate
injury and property damage. To avoid these situations, follow
all instructions and recommendations in the manufacturer’s
Material Safety Data Sheet and product label.
Important: Do not use any acidic cleaners. Doing so will
weaken the paint or powder coatings and void the Precor
Limited Warranty. Never pour water or spray liquids directly
on the console or console’s screen.
It is important to avoid using any corrosive chemicals on the
console or screen.
Always dampen the cloth and then clean the screen. Be sure
to spray the cleaning liquid onto the cloth, not the screen, so
that drips do not seep into the console.
Apply the cleaner with a soft, lint-free cloth. Avoid using gritty
cloths.
Changing the Belt (AMT Only)
The AMT uses belts to provide motion. These belts eventually
wear and must be replaced.
When the belt stride count reaches 90 million, the message
BELTS MUST BE CHANGED SOON scrolls on the Welcome
screen. While this message appears, the AMT operates
normally.
Important: If this message displays on your AMT, please contact
Precor Customer Support for assistance.
When the belt stride count reaches 100 million (and the belt
has not been changed), the message BELTS CHANGE
REQUIRED scrolls continuously on the Welcome screen. The
input keys are not functional and the user cannot enter values
or begin a workout until the belts are changed. Please contact
Precor Customer Support to schedule a belt change.
To Next Page
Loading...
Need help?
General
