PROLiNK Professional II+ Series User Manual

6
Warning
:
• Make sure the DC breaker or other protection device between the UPS and the external battery is plugged
in. If not, please install carefully. Turn off the Battery breaker before installation.
NOTE:
Set the breaker on the external battery in the "OFF" position and then plug it in External battery.
• Pay close attention to the rated battery voltage marked on the back panel. If you want to
change the battery number, make sure you change the settings at the same time. Splicing
with the wrong battery voltage can cause permanent damage to the UPS. Make sure
The battery voltage is correct.
• Pay close attention to the polarity markings on the external battery terminal blocks, and confirm polarity
The correct battery is connected. Incorrect connection can cause permanent damage to UPS.
• Make sure the protective ground cable is properly seated. Current value, color specifications, position,
The connection and reliability of cable conductance must be carefully checked.
• Make sure the utility cable inputs & outputs are correct. Current value, color specifications, position,
Relationship. The reliability of cable conductance must be carefully checked. Ensure proper installation
of L / N, not the other way around and no short circuit occurs.
2-4. Software Installation
For optimal computer system protection, install UPS monitoring software to fully configure shutting down the UPS.
3. OPERATION
3-1. Operation buttons
Knob
Function
ON/Enter key
Ø Turn on the UPS: Press and hold the button for more than 1 second to turn on the
UPS.
Ø Enter key: Press this key to enter the settings menu and select its settings.
OFF/ESC button
Ø Turn off the UPS: Press and hold the button for more than 1 second to turn off the
UPS.
Ø Esc key: Press this key to return to the last menu in the settings menu.
Test/Up button
Ø Battery test: Press and hold the button for more than 0.5 seconds to test the battery
while in AC mode and CVCF mode.
Ø UP button: Press this button to display the next option in the settings menu.
Mute/Down button
Ø Leave the alarm: Press and hold the button for more than 1 second to turn off the
buzzer. Please see section 3-4 "Silence the buzzer" for more details.
Ø Down button: Press this button to display the previous selection in the settings menu.
Test/Up +
Mute/Down button
Ø Press and hold both buttons simultaneously for more than 1 second to enter/exit the
settings menu.
* The CVCF means Converter Mode.

PROLiNK Professional II+ Series Specifications

General

Brand	PROLiNK
Model	Professional II+ Series
Category	UPS
Language	English