User Manual
Page: 12
9. Anti Code / Engineer Restore Facility
9.1 Anti-Code
Your Engineer may have set up the system so that either an ‘Anti-Code’ or 'Engineer Restore' is
required in order to fully reset the wireless alarm system (your code will still silence the alarm,
but it will not reset the system).
After alarm activation has occurred,
enter a valid PIN code, or preset a valid
tag, or press
on the keyfob to silence
the alarm.
The keypad will display as shown to the
right.
Take note of the number, on the screen
and call your Alarm Receiving Centre
(ARC).
Press I.
When the time is displayed, enter the
number given to you by the ARC.
‘Engineer Restore Performed’ will be
displayed.
Press
A .
9.2 Engineer Reset
When the time is displayed, enter the
Engineer code.
‘Engineer Reset Performed’ will be
displayed.
Press A.
To Next Page
Loading...
Need help?
General
