User Manual
Page: 6
3. The KF4-WE (Wireless Keyfob)
The wireless keyfob has 4 buttons that may be programmed for specific purposes (please see
‘CHANGE CODES’ on page 18 for more information).
3.1 Locking the Keyfob
All 4 buttons on the keyfob may be ‘locked’ so that any accidental presses will not affect your
wireless alarm system (for example, this protects the buttons from being pressed accidently if a
keyfob is in someone’s pocket).
3.2 Buttons
The buttons can be customised (see Change Codes, page 18) to operate as desired. The table
below gives the defaults of how each button is programmed. These can be changed in the
‘Change Codes’ function – see page: 18.
LOCK BUTTON = Set Area A
When pressed, the Area A will be start to set.
UNLOCK BUTTON = Unset Area.
When pressed, the wireless alarm system will unset any area that is already
set.
I BUTTON = Set Area B
When pressed, the Area B will be start to set.
II BUTTON = Show Status
When pressed, if the GREEN LED is shown then the wireless alarm system
will be unset. If the RED LED is shown then the wireless alarm system will be
set.
3.3 Quick Setting
If one of the buttons is programmed as ‘Set Area’, the wireless alarm system can be set by
pressing the programmed button on the keyfob. The keypad will then start to count down the
exit time, or wait for a ‘final door’ to be opened and closed or wait for a Push to Set (PTS)
button to be pressed (depending what the exit mode is programmed as by the engineer).
Once the alarm panel is in this ‘setting’ stage, it is possible to ‘quick set’ the system by pressing
the same button again; this will reduce the time to set to ‘immediate setting’. The alarm panel
will revert to the normal display with the time showing, but a beep will be heard once the
system has been set.
Please note this feature cannot be used if ‘Intelligent Setting’ is enabled.
To Next Page
Loading...
Need help?
General
