User Manual
Page: 24
15. Engineer Contacts and Tables
15.1 Engineer Information
Alarm Company
Date of Installation
Site Reference
Engineer Name
Engineer Contact Number
Installed to Grade
Environmental Class II
Your panel is suitable for use in installations designed to meet the European requirements of
Security Grade 2, Environmental Class 2. When all parts are working normally, this equipment
in combination with the PSTN or GSM and suitable ARC equipment will meet the requirements of
ATS2.
External set/unset readers and wireless sirens meet the requirements of environmental class 4.
Number of Code Differs: tag hex code.
Your panel is designed to automatically inhibit certain functionality. The factory default settings
are shown below:
15.1.1 Intruder Alarm Signal
After 3* unconfirmed alarms in the same area or 1 confirmed alarm. * This figure is
programmable by the Engineer.
15.1.2 Tamper Alarm Signal
After 3* unconfirmed alarms in the same area or 1 confirmed alarm. * This figure is
programmable by the Engineer.
15.1.3 Keypad
After 30 key presses without entering a valid code, keys are disabled for 90 seconds. After
reinstatement, this will be repeated after each 7 key presses until a valid code is entered.
15.1.4 Tag Reader (Or Tag at a keypad)
After 6 presentations of an invalid tag, the reader will be disabled for 90 seconds. After
reinstatement, this will be repeated for each invalid tag until a valid tag is used.
15.2 Certification
All Wireless devices comply with the following EU requirements:
EMC Directive 2004/108/EC
Low Voltage Directive 2006/95/EC
R&TTE Directive 1999/5/EC
And meet the following standards where relevant:
EN 61000-6-3:2007
+A1:2011
EMC. Generic emission standard. Residential, commercial and light
industr
EN 50130-4:2011
Immunity requirements for components of fire, intruder and social
EN 60950-1:2006
+A12:2012
Information technology equipment. Safety. General requirements
EN 50131-5-3:2005+
A1:2008
Grade 2. Interconnections for equipment using radio frequency
techniques
ETSI EN 301489-
3:2000
EMC. Radio equipment. Part 3: Short range devices (SRD) 9kHz to
40GHz
ETSI EN 300 220 EMC. Receiver Class 1, Environmental Category 1
CEPT/ERC Recommendation 70-03 Annex 1
Compliant operation is only guaranteed when installed and operated according to the relevant
installation and user manuals.