User Manual
Page: 14
11. Fault Indications / Unable To Set
11.1 Fault Indications
Any faults that occur on the system will
be easily recognised by the flashing
ALERT LED.
To see what the fault is, enter a valid
PIN code, or present a valid tag, or press
on the keyfob.
Depending on how the system has been
set up by your engineer, it may be
possible to set the system with a fault,
to do this press I.
Any fault may affect the overall performance of your alarm control panel and therefore your
engineer should be contacted for further assistance if any fault is active.
11.2 Unable to Set
If ‘unable to set’ is displayed, it indicates
that an input is open and the area where
the input is should be checked for open
windows, pets, movement etc.
If the problem cannot be solved contact
your Engineer, or omit the input (page
15)
11.3 Keyfob Fault Indications
If the panel is unable to set for any reason, the keyfob status LED flashes AMBER indicating a
fault is on the system. The fault will be shown on the keypad.