Pyronix Enforcer 32-WE Wireless Setup Guide

Enforcer 32-WE Wireless Setup Manual
Page: 14
9. Wireless Peripherals
This section describes most of the wireless peripherals that can be learnt to the Enforcer 32-WE.
9.1 MC1MINI-WE
The MC1MINI-WE is a Two Way wireless magnetic contact with 1 reed switch.
9.1.1 Learning / Diagnostics / Installation
9.1.2 Installation Notes
It is recommended the MC1MINI-WE is learned at the control panel. A signal strength test should
then be performed to make sure the most suitable location is chosen, ensuring optimum wireless
range.
9.1.3 Installation Surfaces
NOTE: The MC1MINI-WE can be mounted on typical building materials; such as wood, PVC, brick
or metal etc. If you do encounter any problems with different surfaces, please contact
customer.support@pyronix.com
WIRELESS DEVICE
CONTROL?
Learn Devices?
Control Inputs?
Input 01
Available [01]
Learning...
LEARN
START
>5s
Input Learnt!
DIAGNOSTICS?
View Wireless
Device Status?
Signal Strength?
Inputs?
333333----------
----------------
5s
≤300s
LEDs
LEDs
No. 6.
Pan Head
Screw
CHANGE INPUTS?
Input [01]
Input 01
Input Type [07]
Final Exit
Input Active In
[ABCD]
>10m
10m

Pyronix Enforcer 32-WE Specifications

General

Brand	Pyronix
Model	Enforcer 32-WE
Category	Security System
Language	English