Enforcer Programming Manual
Page: 8
3.6 Set / Unset System
Setting and unsetting the system can be done using the Engineer code.
1. Enter the Engineer code (default 1111).
2. Press if any faults appear.
3. 'SET/UNSET SYSTEM' is displayed.
4. Press .
5. Select the areas to set. Press .
6. The setting period will begin.
7. Once the timer expires, and a beep is heard, the Enforcer
32-WE is set.
8. To unset, enter the engineer code again.
3.7 Forced Arm On Inputs
The 'Force Arm On Inputs' function enables two nominated inputs on the Enforcer 32-WE to be set.
Either input can be triggered to allow real life signalling or alarm testing. This function is useful when
a building is full of people and these tests are needed.
NOTE 1: The system will give the correct signalling response to the Setting, and any resulting alarm.
NOTE 2: If the system has been set by any other code, the Engineer code will not unset it.
1. Enter the Engineer code (default 1111).
2. Press if any faults appear.
3. 'SET/UNSET SYSTEM' is displayed.
4. Press .
5. 'FORCE ARM ON 1st INPUT' is displayed.
6. Enter the 1st input that is to be active. Press .
7. Enter the 2nd input that is to be active. Press .
8. Select the areas to set. Press .
9. The setting period will begin
10. Once the timer expires, and a beep is heard, the
Enforcer 32-WE is set and the 2 inputs chosen will be
active.
11. To unset, enter the engineer code again.
SET / UNSET
SYSTEM?
SET AREAS
[A ]
Setting [007]
Full Set
FORCE ARM ON 1st
INPUT? [01]
FORCE ARM ON 2nd
INPUT? [01]
SET AREAS
[A ]
To Next Page
Loading...
Need help?
General
