13
ENFORCER V11 EXTENDED USER GUIDE
UNABLE TO ARM
Control Panel Indication
If ‘unable to set’ is displayed, it indicates that a zone is open
and the area where the zone is should be checked for open
windows, pets, movement etc.
If the problem cannot be solved contact your engineer, or
bypass the zone.
Unable To Set
Input 01
Keyfob Indication
If the panel is unable to arm for any reason, the keyfob status LED ashes amber indicating a fault is on the system.
ADVANCED FUNCTIONS
CHIME
The chime can be used for any zone on the system. This can be
programmed by your engineer.
To enable the chime on the keypad, when the time is displayed,
press c.
‘c’ will be displayed on the right side of the keypad display. Press
c again to clear the chime feature.
Alarm Panel
Time 10:09 c
OMITTING ZONES
On occasion, a detector may need to be isolated if a room is
occupied.
Enter your User Code.
Press f.
Select the zones that need to be bypassed’
Press h.
After 10 seconds the exit time continues.
Select Omit [01]
Input 01
Please note: Zones have to be programmed as bypassable by your engineer for this feature to operate.
KEYPAD HOLD UP
A ‘hold up’ alarm will be generated when 1 and 7 are
pressed and held down for 2 seconds (this time period can be
altered by your engineer).
Alarm Silenced
2 Key HU
Please note 1: The keyfob can also be programmed to provoke a hold up alarm. All hold up alarms including
duress codes must be enabled by the engineer.
Please note 2: This feature is not available from the tablet application.
To Next Page
Loading...
Need help?
General
