Matrix User Guide
RINS915-2 Page: 43
5.16 Adding / Removing Key fobs
Icon Keypad LCD Keypad
Note: If a key fob (KF4DW) has already been
learnt, you will need to delete the previous user’s
information from the key fob before attempting to
re-assign it. Please see below.
Adding Key Fobs
Enter a
Enter the two digit user number ( - UT), you
wish to assign to this key fob OR use the > and ?
keys to locate a valid user number (followed by the
key).
If the display shows a user number, then a key fob is
already programmed for that user. You will either
need to choose a new user (press the a key and go
back into the function) or remove the user by
pressing the F
key.
To add the key fob to the chosen user, simply insert
the battery into the KF4DW. The ORANGE LED will
flash and the keypad will make an acceptance tone.
The user function will automatically end and you will
be returned to user mode.
Removing Key Fobs
Enter user mode.
Enter a
Enter the two digit user number ( - UT ), you
wish to assign to the key fob OR use the > and ?
keys to locate a valid user number (followed by the
key).
To remove the key fob from this user press the >
key once. An acceptance tone will be played and you
will be returned to user menu mode.
Note: You will still need to perform an NVM reset on
the KF4DW after you have deleted a key fob at the
Matrix keypad.
Note:
If a key fob (KF4DW) has already been
learnt, you will need to delete the previous user’s
information from the key fob before attempting to
re-assign it. Please see below.
Use the
and
keys to navigate to “ADD KEYFOB”.
The following display will be shown:
Press to select this option.
The following display will be shown:
Use the
and
keys to select the user you wish
to be associated with the key fob then press B.
The following screen will be displayed.
Note: Pressing
at this point will return
you to the main menu.
If the above display shows a user number on the
bottom line, then a key fob is already programmed
for that user. You will either need to choose a new
user (press the key and go back into the
function) or remove the user by pressing the
key.
To add the key fob to the chosen user, simply insert
the battery into the KF4DW. The ORANGE LED will
flash and the keypad will make an acceptance tone.
The user function will automatically end and you will
be returned to user mode.To remove a currently
programmed key fob from a selected user, press ,
you will be returned to the main menu and the key fob
will be erased from the panel.Note: You will still need
to perform an NVM reset on the KF4DW after you
have deleted a key fob at the Matrix keypad.
To Next Page
Loading...
Need help?
General
