Connecting Power and Turning On 4-7
Connecting Power and Turning On
Step 1 Plug the power cord into the back of the 4000/
7000DLT Series.
Step 2 Plug the power cord from the 4000/7000DLT Series
into a GROUNDED electrical outlet.
Step 3 Plug the power cord from your host system into the
same GROUNDED electrical circuit if possible.
Computers and peripherals should always share
the same grounds.
Step 4 Turn ON the power to your host system.
Step 5 Turn the 4000/7000DLT Series power ON.
Installing the Backup Software
At this point, please refer to your backup software installation
guide and install the backup software.
After you have completed installation of your 4000/7000DLT
Series and the backup software, you should run a small
backup/restore and compare to confirm that your unit is
working correctly. See your software installation guide for
additional information.
Note
Turning on the
host computer
first ensures that
the SCSI bus
terminators
stabilize the bus
signals before the
tape drive is
turned on.
To Next Page
Loading...
Need help?
General