FCC Notices (U.S. Only) C-3
C-
FCC Notices (U.S. Only)
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance
with the manufacturer's instruction manual, may cause
interference with radio and television reception. This
equipment has been tested and found to comply with the
limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment
does cause harmful interference with radio or television
reception, which can be determined by turning the equipment
off and on, you are encouraged to try to correct the
interference by one or more of the following measures:
• Reorient the receiving antenna.
• Relocate the computer with respect to the receiver.
• Move the computer away from the receiver.
• Plug the computer into a different outlet so that the
computer and the receiver are on different branch circuits.
If necessary, consult an experienced radio/television
technician for additional suggestions. You may find the
following booklet helpful:
• FCC Interference Handbook, 1986, available from the U.S.
Government Printing Office, Washington, DC 20402,
Stock No. 004-000-00450-7.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
• This device may not cause harmful interference.
• This device must accept any interference received,
including interference that may cause undesired
operation.
Shielded Cables
Use only shielded cables for connecting peripherals to this
device to reduce the possibility of interference with radio and
television reception. Using shielded cables ensures that you
maintain the appropriate FCC radio frequency emissions
compliance (for a Class A device) or FCC certification (for a
Class B device) of this product.
To Next Page
Loading...
Need help?
General