Quantum 4000 User Manual

5-4 Operation and Maintenance
62-0162-01
Drive Status
LED Indicators
After initialization, the drive will be in one of the four states
listed in Table 5-1.
Table 5-1 Drive States Indications
Drive State LED Indicator Displays and Drive Actions
No cartridge is present. The
Ta
p
e in Use
LED turns OFF.
The
O
p
erate Handle
LED turns ON.
The handle is unlatched.
The drive beeps momentarily.
A cartridge is present and
the handle is down.
The drive loads the cartridge.
When the
Ta
p
e in Use
LED stops blinking and stays
ON, the tape’s actual density lights. For example, if
the actual tape density is 2.6, then the LED turns ON
next to the 2.6 label.
When the
Densit
y
Override
LED blinks, you can
select a density. The drive is ready for use.
A cartridge is present, but
the handle is up (not
recommended).
The
Ta
p
e in Use
LED turns OFF. The
O
p
erate
Handle
LED flashes.
When you lower the handle, the cartridge loads.
The drive detects an error
condition.
Then all right or left side LEDs blink repeatedly.
You may try to unload the tape (if present) and
reinitialize the drive by pressing the
Unload
button
or turn power OFF and then ON again. The right or
left side LEDs stop blinking and the drive tries to
reinitialize. The LEDs turn ON steadily again and
then turn OFF if the test succeeds.

Quantum 4000 Specifications

General

Brand	Quantum
Model	4000
Category	Storage
Language	English